PlayFix

How to use a hot air station for phone repair

Short answer: To use a hot air station for phone repair, apply flux, shield nearby heat-sensitive parts, and heat the component evenly with a suitable nozzle, moderate airflow and a temperature that melts the solder without overheating the board. Lift the part only when all the solder has melted, then clean the pads and fit the new part the same way.

Settings

Exact temperatures depend on the station, nozzle and solder. Start lower and increase slowly. Use moderate airflow for small parts so they are not blown away, and keep the nozzle moving.

Protect the board

  • Shield plastic connectors, cameras and nearby chips with heat tape or a shield
  • Preheat the board when working on large chips
  • Do not heat one spot for too long
  • Use plenty of good flux

Removing and fitting a component

  1. Clean the area and apply flux.
  2. Shield nearby heat-sensitive parts.
  3. Heat the component evenly in small circles.
  4. When the solder melts, lift the part gently with tweezers.
  5. Clean the pads, add fresh flux, and place the new part.
  6. Heat until it settles into place, let it cool, and clean off the flux.

Watch the repair

Learn it step by step

Frequently asked questions

What temperature should I use?

It depends on your station, nozzle and solder. Start low and increase slowly until the solder melts in a reasonable time.

Why use flux?

Flux helps solder melt and flow evenly and protects the joint from oxidation.

Can hot air damage the board?

Yes. Too much heat can lift pads, warp the board or damage nearby parts. Shield them and do not overheat.

Related guides

More free lessons

Written by the PlayFix repair team. Updated 2026-11-06.