PlayFix

How to find a short circuit on a phone motherboard

Short answer: To find a short circuit on a phone motherboard, confirm it by measuring the rail to ground in diode mode, then inject a low, current-limited voltage into that rail and find the component that heats up first, using a thermal camera, rosin smoke or isopropyl alcohol that dries fastest on the hot part.

What a short circuit is

A short means a power line is connected to ground through a failed part, usually a capacitor or a chip. The rail cannot hold its voltage, the board draws high current and it may not turn on.

Tools that help

  • Multimeter with diode mode
  • DC power supply with current limit
  • Thermal camera, rosin or isopropyl alcohol
  • Schematic or boardview to know what is on the rail
  • Microscope and hot air for replacement

Finding the short

  1. Remove the battery and measure the suspect rail to ground in diode mode. A reading near 0 confirms the short.
  2. Use the schematic or boardview to see every component on that rail.
  3. Set the power supply to a low voltage, no higher than the rail's normal voltage, with a limited current, and connect it to the rail and ground.
  4. Watch the board with a thermal camera, or apply rosin smoke or alcohol, and find the part that heats or dries first.
  5. Remove the suspect part and measure the rail again.
  6. Replace it with a good part of the same value and test the board.

Watch the repair

Learn it step by step

Frequently asked questions

What voltage should I inject to find a short?

Use a voltage at or below the rail's normal working voltage, with a current limit, so you do not damage other parts.

Is it usually a capacitor?

Very often, yes. Small filter capacitors on power rails are the most common shorted parts, but chips can short too.

Can I find a short without a thermal camera?

Yes. Rosin smoke or isopropyl alcohol on the board shows the hot spot as well.

Related guides

More free lessons

Written by the PlayFix repair team. Updated 2026-11-06.