What is an OVP IC in a mobile phone?
Short answer: An OVP IC (Over Voltage Protection integrated circuit) is a small chip on the charging path of a phone. It sits between the USB port and the charging circuit and cuts the connection when the input voltage is too high, so a bad charger cannot damage the battery charger IC or the rest of the board.
OVP full form and meaning
OVP stands for Over Voltage Protection. On a phone motherboard it is a small chip, usually next to the USB charging port connector, that watches the voltage coming in on the VBUS line.
If the charger supplies a normal voltage the chip stays closed and passes power through. If the voltage rises above its limit, for example from a faulty or fake charger, it opens and isolates the board.
Where the OVP IC is on the board
Look near the charging port. VBUS comes from the port, passes through the OVP chip and then continues to the main charging IC or PMIC. Many boards also have a filter capacitor on VBUS right next to it.
The exact part and its position differ by model, so always use the schematic or boardview of the phone you are repairing.
Symptoms of a faulty OVP IC
- Phone does not charge at all, or the charging icon never appears
- A short circuit on the VBUS line, with a hot chip and a charger that drops voltage
- Charging works only with some cables or chargers
- Visible burn marks or corrosion around the chip after liquid damage or a bad charger
- Fake charging: the icon appears but the battery percentage does not rise
How to test an OVP IC
- Check the cable, charger and charging port first, and clean any lint or corrosion from the port.
- Set a DC power supply to 5 V with a current limit and connect it to the VBUS line, or use a USB ammeter on the charger. Note the current.
- With the multimeter in diode mode, measure the VBUS line to ground. A reading near zero means a short.
- If there is a short, inject a low limited voltage and look for the component that heats up first, often the OVP chip or a capacitor beside it.
- Compare the readings with a known-good board of the same model if you have one.
- Replace the faulty OVP IC or capacitor with micro-soldering, then test charging again under the power supply.



