How to Reball power ic of mobile phone
In this video you will watch how I Reball power ic of a mobile phone.
This is a preview of a rewarded PlayFix lesson. Sign in to see its viewing options; playback is not available on this preview page.
Open lesson on PlayFixMicro-soldering for phone repair
Micro-soldering covers the precise board work behind most chip-level phone repairs: removing shields, lifting and reballing BGA chips, repairing torn pads, running jumper wires and replacing connectors. Good flux, temperature control and magnification matter as much as the iron or hot-air station.
Testing phone board components
Board-level repair depends on knowing whether a component is good. Capacitors, coils, diodes, filters and power ICs can be checked with the multimeter diode, resistance and continuity modes, by comparing readings with a known-good board, or by spotting heat when voltage is injected.
What a technician checks
- Protect nearby parts before applying hot air
- Use enough flux and controlled temperature
- Clean pads before reballing or refitting an IC
- Inspect joints under a microscope after the repair
- Use diode mode to compare line readings with a good board
- Check capacitors for a short to ground